Needle Bearing GE & Mini-Cup Clutches (13T & Up) Chain Tension Bolt and does not require a

and does not require a lot of moving components or hardware

1040mm width: This axle width is the most common for 40mm axles

These have been discontinued so available while supplies last

Each hub is drilled and tapped to fit either 1/4" or 5/16" wheel studs

This support braces and neatly organizes the shifting cable assemblies that jut out of the control plate for the up-shift and down-shift mechanisms on the DD2 kart engine

Needle Bearing GE & Mini-Cup Clutches (13T & Up) Chain Tension Bolt and does not require aNeedle Bearing for Noram GE and Mini Cup Clutches (13T and Up). This needle bearing will fit the Noram GE clutch and Mini Cup Clutches for these sizes of drive sprockets. Each needle bearing comes as pictured, and requires regular service and maintenance with re packing the needles!